Power Board Safety Tips

Tuesday, June 02, 2015

Electrical Powerboards Safety Tips

 

The wide utilisation of powerboards in homes throughout Australia confirms people's reliance on these devices. You will find most people unaware of the risks of power boards if used incorrectly. Electricity has the potential to kill people if proper care isn't adhered to, hence the reason why some simple steps should be followed when connecting electrical appliances to powerboards. 

In Australia the typical household electrical power point voltage is 240V and the current is rated 10A. Accordingly, the manufacturers of power boards will design their products to meet that electrical rating. Often people will overload the powerboards with too many devices, for example, when connecting the electric heater, computer and its interconnected peripheral devices will at times exceed the recommended safety rating of a power board. Since heaters can draw big currents such as 3.6Amps at times. Therefore it doesn't take much for the powerboard rating to be reached.

 

Don't

 

Do not overload the powerboard with too many big current consuming electrical appliances, for example, heaters draw big current

 

Do not exceed the manufacturer’s voltage and current rating, for example 10Amps and 240V

 

Do not use double adaptors on the powerboard

 

Do not position the powerboard in hot areas, for example, avoid placing near heater and sunny hot glass window

 

Do not join or interconnect powerboards together, for example, no daisy-chains

 

Do not use a thinner extension cable before powerboard

 

Do not locate near water or moisture

 

 

Do

 

Keep adequate ventilation near powerboards to reduce heat build-up

 

Keep young children away and out of reach

 

Check rating of the electrical appliances before connection to powerboards

 

Ensure the combined total Amps (current) consumption of appliances doesn’t exceed the Amps (current) of the powerboard

 

Buy a powerboard with overload protection and surge protection

 

Buy powerboards with individually switched outlets and wide spacing for power packs

 

Visually and physically inspect powerboards for damage regularly

 

Turn off appliances at powerboard and power point switch when not in use

 

Only use powerboards designed to meet Australian Electricity Standards

These easy to follow safety guidelines should be considered when dealing with electrical powerboards. If at any time you think there could be an electrical hazard keep clear and immediately contact an electrician for assistance. Remember your meter box generally is located outside of the premises, and will have a circuit breaker you can turn-off the electricity till a licensed electrician inspects the wiring.

For further information see the new edition of the Australian / New Zealand Standard for Wiring Rules (AS/NZS 3000:2007).

Source available: http://www.cits.net.au/electrical-powerboards-safety

 

 

Leave your comment